Factory maintenance schedule OEM · verified
Normal service, condensed from the factory interval matrix.
| Every 100,000 mi | Oxygen Sensor (replace) |
Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1996 318I.
The 1996 BMW 318I is an E36-platform model equipped with a four-speed automatic transmission and a service regimen specifying 5.3 quarts of API SJ oil in 15W-40, 10W-40, or 10W-30 viscosity grades, while EPA estimates rate it at 19 mpg city, 28 mpg highway, and 22 mpg combined. Within the 1991–2001 model span, this year registers the lowest complaint volume of the entire run at just three owner reports, with air bags cited as the top concern and a single recall on file. That tally makes 1996 the most complaint-free year in the eleven-year history, standing apart from the fourteen complaints logged for the 1994 model.
Fluid capacities, tune-up values and fuel economy at a glance.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI 91 · 600 CCA battery, OE oil filter 11421716192. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
| Engine oil filter | 11421716192 |
| Engine air filter | 13721247404 |
| Fuel filter | 13321740985 |
| Spark plug | 12129064619 alt 12129063428 |
| Battery | 61218381724 |
| Front wiper blades | 61611387678 alt 61618182363 |
| Serpentine belt | 11281743193 alt 11281437369 |
| Thermostat | 11531743179 alt 11531743017 |
| Cabin air filter | 64119069895 |
Engine, drivetrain, dimensions and economy.
| Transmission | Automatic 4-spd |
| Overall length | 174.4 in |
| Overall width | 66.9 in |
| Overall height | 54.7 in |
| Wheelbase | 106.3 in |
| Curb weight | 2976 lb |
| Track (front / rear) | 55.9 / 56.3 in |
| EPA city / highway / combined | 19 / 28 / 22 mpg |
| Drivetrain | Rear-Wheel Drive |
| Recommended fuel | Premium Gasoline |
0–60 mph, quarter-mile, horsepower and torque from independent road tests.
Independent road tests for the 318I of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.
| Year | Trim / engine | 0–60 | ¼ mile | HP | Drivetrain |
|---|---|---|---|---|---|
| 1996 | 318 318ti 3-door Hatchback (Club Sport) 1.8L I-4 | 8.50 sec | 16.50 sec | 138 hp | RWD |
| 1995 | 318 318ti 3-door Hatchback (Active) 1.8L I-4 | 7.80 sec | 16.10 sec | 138 hp | RWD |
| 1995 | 318 318ti 3-door Hatchback (Sport) 1.8L I-4 | 8.40 sec | 16.40 sec | 138 hp | RWD |
| 1995 | 318 318i Sedan (Sport) 1.8L I-4 | 8.80 sec | 16.60 sec | 138 hp | RWD |
| 1995 | 318 318ti 3-door Hatchback (Sport) 1.8L I-4 | 8.90 sec | 16.60 sec | 138 hp | RWD |
| 1995 | 318 318ti 3-door Hatchback (Sport) 1.8L I-4 | 9.20 sec | 17.00 sec | 138 hp | RWD |
| 1993 | 318 318i Sedan 1.8L I-4 | 9.70 sec | 17.30 sec | 113 hp | RWD |
| 1991 | 318 318is Coupe 1.8L I-4 | 8.70 sec | 16.40 sec | 134 hp | RWD |
Capacities, torques and tune-up values from the factory service manual.
This engine holds 5.3 qt of 15W-40 / 10W-40 / 10W-30 API SJ engine oil, DOT 4 brake fluid. Torque lug nuts to 88 ft-lbs. The firing order is 1-3-4-2. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Brake Fluid | DOT 4 |
| Differential Gear Oil Capacity | 2.4 Pints |
| Engine Coolant | ETHYLENE GLYCOL |
| Engine Oil | 15W-40 · API · 10W-40 · 10W-30 · 5W-30 |
| Engine Oil Capacity | 5.3 qt |
| Power Steering Fluid | ATF |
| Engine Flywheel Bolts | 86 ft-lbs |
| Oil Pump to Cylinder BLock Bolts/Studs | 16 ft-lbs |
| Driveshaft Flange to Transmission | 145.0 ft-lbs |
| Lug Nuts | 88 ft-lbs |
| Cylinder Firing Order | 1-3-4-2 |
| Ignition Coil Primary Resistance | 0.4-0.8 ohms |
| Spark Plug Manufacturer | BMW |
| Refrigerant | R134a |
| Refrigerant Capacity | 1.76-2.26 lbs |
| Oil Group | PAG |
| Oil Capacity | 4.05-5.06 oz |
| Standard BCI Group Number | 91 |
| Standard BCI Cranking Performance | 600 cca |
| Fuel Pump Pressure Minimum | 51.0-58.0 @ idle psi |
| Fuel Pump Pressure Maximum | 65.0-97.0 psi |
| Injector Primary Resistance | 15-17 ohms |
| Engine Compression | 159 |
| Engine Oil Pressure | 7.25 at idle, 62.35 regulated. psi |
| Intake Valve Lash | Hydraulic in |
| Exhaust Valve Lash | Hydraulic in |
| Brake Application | WITH SOLID ROTOR / WITH VENTED ROTOR |
| Torque Caliper to Bracket | 18-22 ft-lbs / 81 ft-lbs |
| Torque to Knuckle | 49 ft-lbs / 81-96 ft-lbs / 81 ft-lbs |
| Minimum Pad Thickness | Front: 0.079; Rear: 0.079 in |
| Brake Application | WITH SOLID ROTOR / WITH VENTED ROTOR |
| Rotor Minimum Machining | 0.031 in |
| Rotor Discard at or Under | 0.409 in / 0.331 in / 0.803 in / 0.685 in |
| Rotor Finish | 0.5 - 3.5 μin |
| 1 | 4 ft. lbs., Step 1: 4 ft. lbs., Step 3: 70 | 4 ft. lbs |
| 1 | 22 ft. lbs. | 22 ft. lbs |
| 2 | 90 degrees | 90 degrees |
| 3 | 90 degrees | 90 degrees |
| 1 | 14.5 ft. lbs., Step 2: 50 | 14.5 ft. lbs |
Normal service, condensed from the factory interval matrix.
| Every 100,000 mi | Oxygen Sensor (replace) |
Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.
The 1996 model year represents a statistical low point for consumer complaints within this generation, recording only 3 complaints compared to 14 in both 1994 and 1995. While Technical Service Bulletins remained high at 6, matching the 1995 peak, the federal recall count decreased to 1, which is equal to the 1997 model year but lower than the 3 recalls seen in 1992. Specific federal data for 1996 highlights Air Bags and Power Train as the top complaint areas, accounting for 2 and 1 incidents respectively, with 2 crash complaints recorded. This sharp decline in reported issues contrasts with the subsequent rise to 11 complaints in 1998, placing the 1996 model at the most favorable point in the provided dataset. Consequently, the 1996 BMW 318I appears to be a strong candidate for purchase based on its superior federal safety and reliability record relative to adjacent model years.
All 3 complaints on record, top 2 components.
Source: NHTSA Office of Defects Investigation complaint database.
Showing 1 of 1 campaigns on record for this vehicle.
THE CRUISE CONTROL AND THROTTLE CABLES ARE ATTACHED TO THE SAME THROTTLE VALVE ACTUATING LEVER AT THE THROTTLE HOUSING. IT IS POSSIBLE THAT THE PLASTIC BUSHING ON EITHER CABLE COULD BREAK DUE TO ENVIRONMENTAL INFLUENCES… Remedy: DEALERS WILL INSTALL A SPRING STEEL CLIP ON THE OUTER TUBE OF EACH CABLE IN THE AREA OF THE ADJUSTING SCREW AND PLASTIC BUSHING. THE CLIP IS DESIGNED TO PREVENT THE OUTER TUBE…
Showing 5 of 6 bulletins on record with NHTSA.
| Bulletin | Date | Component | Summary |
|---|---|---|---|
| B510819 | 2024-01-16 | Electrical System | The basic conditions for initializing the power windows are not met. |
| 12 15 96 | 1997-11-01 | Vehicle Speed Control | ROUGH IDLE |
| 12 15 96 | 1997-02-01 | Electrical System | M44 MISFIRE FAULTS 50, 51, 52 OR 53. *TW |
| 12/15/96 | 1996-12-01 | Engine And Engine Cooling | M44 MISFIRE FAULTS 50, 51, 52 OR 53. *TW |
| 54/09/96 | 1996-11-01 | Visibility | SUNROOF FAILS TO CLOSE. *TW |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.
5.3 qt of HIGH PERFORMANCE MINERAL OILS: ABOVE 5 degrees F: 15W-40 API SJ, SL OR SM, -5 degreesF TO 68 degrees F: 10W-40 API SJ, SL OR SM, 5 degreesF TO 50 degrees F: 10W-30 API SJ, SL OR SM, BELOW 50 degrees F: 5W-30 API SJ, SL OR SM, BELOW 32 degrees F:, per the factory manual.
NHTSA lists 1 recall campaign(s) for this model year. Check your specific vehicle by VIN.
EPA figures are 19 city / 28 highway / 22 combined mpg.