Subaru›GL-10›1985›Overview/subaru/gl-10/1985/base/

10 platform

1985 Subaru GL-10

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1985 GL-10.

The 1985 Subaru GL-10, built on the 10 platform, represents Subaru's entry-level sedan of this era, equipped with a boxer engine that calls for 4.2 quarts of oil within the 10W-30 to 10W-50 viscosity range meeting API SM standards. For researchers examining this model's place in Subaru's historical lineup, the 1985 GL-10 presents a notably restrained complaint profile with only eight documented owner complaints—suspension cited as the primary area of concern—alongside three recalls, suggesting fewer endemic issues compared to other model years in the reliability record and making it a useful baseline for understanding this generation's typical failure patterns.

Model year1989 1988 1987 1986 1985

Quick specs

Fluid capacities, tune-up values and fuel economy at a glance.

Engine oil capacity4.2 qtOEM · verified

Engine oil type10W-30 / 10W-40 / 10W-50 API SMOEM · verified

Performance & power Independent road tests

0–60 mph, quarter-mile, horsepower and torque from independent road tests.

Independent road tests for the GL-10 of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.

10.3 sec0–60 mph (tested)quickest 10.30 sec — 1986 Turbo Sedan

Year	Trim / engine	0–60	¼ mile	HP	Drivetrain
1986	Turbo Sedan 1.8L Turbo F-4	10.30 sec	17.60 sec	111 hp	4WD

Service quick specs OEM factory data

Capacities, torques and tune-up values from the factory service manual.

This engine holds 4.2 qt of 10W-30 / 10W-40 / 10W-50 API SM engine oil, 80W-90 · GL-5 in the differential, DOT 3 brake fluid.

Lubricants & capacities

Brake Fluid	DOT 3
Differential Gear Oil	80W-90 · GL-5
Differential Gear Oil Capacity	1.5 Pints
Engine Coolant	ETHYLENE GLYCOL
Engine Oil	10W-30 · 10W-40 · 10W-50 · API
Engine Oil Capacity	4.2 qt
Transfer Case Fluid	75W-90 · GL-5
Transfer Case Fluid Capacity	2 Pints

Factory maintenance schedule OEM · verified

Normal service, condensed from the factory interval matrix.

Under the factory schedule, replace the engine oil and filter at 3,000 mi.

At 3,000 mi	Engine Oil Filter (replace)
Every 7,500 mi	Engine Oil (drain & refill) · Engine Oil Filter (replace)
Every 15,000 mi	Body Latches, Locks & Hinges (inspect) · Brake System (inspect) · Clutch Assembly (inspect) · Engine Coolant System (leak inspection) · Hill Holder System (inspect) · Power Steering System (inspect)
Every 30,000 mi	Accessory Drive Belt (inspect) · Brake Drum Assembly (inspect) · Brake Hydraulic System (drain, refill & bleed) · Brake Power Booster Unit (inspect) · Differential (inspect fluid level) · Engine Air Filter Element (replace)
Every 60,000 mi	Emission Control System (inspect)

Reliability & federal safety record

Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.

Owner complaints about the 1985 Subaru GL-10 lead in one area — the suspension, 2 of 8 reports (25%), well ahead of the next concern. That matters, because the suspension are also the target of recall 90V-086 on this vehicle — so the single most useful check before buying or servicing one is confirming it was actually performed. 0 of the reports describe a crash and 0 a fire — a small share of the total, but worth weighing against the suspension pattern above. These are tallies of what owners actually reported to the federal government, not an editorial score — and higher-selling models naturally rack up more reports.

Open recalls

NHTSA campaigns

Service bulletins

Manufacturer communications

ODI investigations

Office of Defects Investigation

Owner complaints

0 involved a crash · 0 a fire

Owner complaints filed with NHTSA, by component

All 8 complaints on record, top 7 components.

Suspension2

Suspension,Power Train1

Service Brakes, Hydraulic,Engine & Engine Cooling1

Wheels1

Seat Belts1

Vehicle Speed Control1

Structure1

Source: NHTSA Office of Defects Investigation complaint database.

Recalls NHTSA · verified

Showing 2 of 3 campaigns on record for this vehicle.

05E065000Fuel System, GasolineReported 05/10/2005

CERTAIN SPX FILTRAN FUEL FILTERS WITH A 45-DEGREE ANGLE INLET TUBE, MODEL 800F350-S1, SOLD AS REPLACEMENT FILTERS FOR 1993-1997 FORD PROBE,1993-2001 MAZDA 626 AND MX-6, AND 1983-1994 LOYAL, 3-DOOR COUPE, HATCHBACK… Remedy: SPX WILL NOTIFY ITS CUSTOMERS AND PROVIDE A FULL REFUND. THE RECALL BEGAN SEPTEMBER 27, 2005. OWNERS MAY CONTACT MR. CHRIS GREESON AT 704-869-3733 OR CONTACT THE WIX INFORMATION…

90V086000Suspension:RearReported 07/05/1990

CONTINUOUS EXPOSURE TO ROAD SALT COULD CAUSE CORROSION OF REAR SUSPENSION COMPONENTS, ESPECIALLY THE INNER ARMS. Remedy: RUST PROOF OR REPLACE REAR SUSPENSION, AS NECESSARY.

Technical service bulletins NHTSA · verified

Showing 5 of 10 bulletins on record with NHTSA.

Bulletin	Date	Component	Summary
15-302-22	2022-08-23	Equipment	This bulletin contains illustrations of exchange components and their manufacturer as…
01-167-08R	2022-08-23	Equipment	This bulletin contains additional information for recommended materials listed in the…
15-192-22R	2022-03-18	Electrical System	This bulletin has been developed to outline the steps for gathering basic essential…
01-167-08R	2021-06-17	Electrical System	This bulletin contains additional information for recommended materials listed in the…
09-51-08R	2021-06-07	Equipment	This bulletin is to advise of SOAâs revised catalytic converter recycling program…

Common OBD-II trouble codes

The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.

P0420

Catalyst system efficiency below threshold — Bank 1

P0300

Random / multiple cylinder misfire detected

P0171

System too lean — Bank 1

P0455

Evaporative emission system leak detected — large leak

P0128

Coolant thermostat below regulating temperature

P0442

Evaporative emission system leak detected — small leak

VIN tools

Decode factory build data for a specific vehicle by VIN.

VIN

Decode a VIN to confirm the transmission and build data for a specific GL-10. OEM

Build data

Plant, GVWR class, engine and body data for any 17-character VIN.

Recalls

Check open recall campaigns against a specific vehicle by VIN.

Vehicles with shared specs

Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.

Vehicles taking 4.2 qt 10-platform vehicles

Reference guides

Cross-vehicle references for the kinds of data on this page.

Vehicle recalls & TSBs OBD-II trouble codes Maintenance schedules Fluid capacities & specs

Frequently asked

How much oil does the 1985 GL-10 take?

4.2 qt of 10W-30, 10W-40 OR 10W-50 API SM, per the factory manual.

Does the 1985 GL-10 have open recalls?

NHTSA lists 3 recall campaign(s) for this model year. Check your specific vehicle by VIN.