Oldsmobile›Cutlass Salon›1986›Overview/oldsmobile/cutlass-salon/1986/base/

1986 Oldsmobile Cutlass Salon

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1986 Cutlass Salon.

The 1986 Oldsmobile Cutlass Salon specifies a 4‑quart engine oil capacity with a 5W‑30 API viscosity recommendation. Owner‑reported data tallies 31 complaints, the majority targeting the engine and cooling system, and the model was recalled three times. Those figures place the 1986 Salon among the more complaint‑intensive years of the Cutlass line, signaling that careful attention to the cooling system is advisable for longevity.

Model year1987 1986 1985 1980 1979 1978 1977 1976 1975

Quick specs

Fluid capacities, tune-up values and fuel economy at a glance.

Engine oil capacity4 qtOEM · verified

Engine oil type5W-30 APIOEM · verified

Full specifications

Engine, drivetrain, dimensions and economy.

Dimensions & weight NHTSA vPIC

Overall length	190.6 in
Overall width	69.7 in
Overall height	54.3 in
Wheelbase	104.7 in
Curb weight	2734 lb
Weight distribution (front / rear)	64/36

Service quick specs OEM factory data

Capacities, torques and tune-up values from the factory service manual.

This engine holds 4 qt of 5W-30 API engine oil, 80W-90 · GL-5 in the differential, DOT 3 brake fluid.

Lubricants & capacities

Brake Fluid	DOT 3
Differential Gear Oil	80W-90 · GL-5
Differential Gear Oil Capacity	4.4 qt
Engine Coolant	ETHYLENE GLYCOL
Engine Oil	5W-30 · API
Engine Oil Capacity	4 qt
Engine Oil	5W-30 · API
Engine Oil Capacity	4 qt

Factory maintenance schedule OEM · verified

Normal service, condensed from the factory interval matrix.

Under the factory schedule, replace the engine oil and filter at 7,500 mi.

At 7,500 mi	Carburetor Mounting Fasteners (inspect) · Choke System (inspect) · Drive Axle Assembly (drain & refill) · Engine Oil Filter (replace) · Tire & Wheel Assembly (rotate)
Every 7,500 mi	Body Latches, Locks & Hinges (inspect) · Brake System (inspect) · Differential (inspect fluid level) · Engine Oil (drain & refill) · Exhaust System (Complete) (inspect) · Parking Brake Cable (lubricate)
Every 15,000 mi	Engine Oil Filter (replace) · Tire & Wheel Assembly (rotate)
Every 30,000 mi	Accessory Drive Belt (inspect) · Choke System (inspect) · Distributor Cap (inspect) · Distributor Vacuum Advance (inspect) · EGR System (inspect) · Engine Air Filter Element (replace)
Every 100,000 mi	Transmission Fluid & Filter (replace)

Reliability & federal safety record

Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.

Owner complaints about the 1986 Oldsmobile Cutlass Salon lead in one area — the engine & engine cooling, 6 of 31 reports (19%), well ahead of the next concern. None of this vehicle's 3 recall campaigns target the engine & engine cooling, so those reports read as owner-reported wear-and-tear rather than an acknowledged defect. 1 of the reports describe a crash and 3 a fire — a small share of the total, but worth weighing against the engine & engine cooling pattern above. These are tallies of what owners actually reported to the federal government, not an editorial score — and higher-selling models naturally rack up more reports.

Open recalls

NHTSA campaigns

Service bulletins

Manufacturer communications

ODI investigations

Office of Defects Investigation

Owner complaints

1 involved a crash · 3 a fire

NHTSA crash-test rating federal NCAP · out of 5 stars

Overall★★★★★

Frontal★★★★★

Side★★★★★

Rollover★★★★★

Owner complaints filed with NHTSA, by component

All 31 complaints on record, top 8 components.

Engine & Engine Cooling6

Structure4

Power Train3

Vehicle Speed Control3

Service Brakes, Hydraulic3

Steering3

Tires2

Electrical System2

Source: NHTSA Office of Defects Investigation complaint database.

Recalls NHTSA · verified

Showing 2 of 3 campaigns on record for this vehicle.

89V102000Vehicle Speed ControlReported 16/06/1989

A SMALL NYLON BUSHING IN THE CRUISE CONTROL SERVO BAIL MAY SLIP OUT OF PLACE, CAUSING INTERMITTENT AND UNEXPECTED INCREASES IN ENGINE SPEED OR DIESELING (ENGINE RUN ON WITH IGNITION OFF). Remedy: INSTALL A NEW BUSHING IN CRUISE CONTROL SERVO BAIL.

86V061000Electrical System:Wiring: Rear Compartment/TrunkReported 13/05/1986

AN INCORRECTLY INDEXED WIRING HARNESS MAY CAUSE THE CENTER HIGH MOUNTED STOP LAMP TO REMAIN ILLUMINATED WHEN THE HEADLIGHTS OR PARKING LAMPS ARE ON. FMVSS 108 LAMPS, REFLECTIVE DEVICES AND ASSOCIATED EQUIPMENT REQUIRES… Remedy: CORRECTLY INDEX WIRING HARNESS TERMINALS.

Common OBD-II trouble codes

The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.

P0420

Catalyst system efficiency below threshold — Bank 1

P0300

Random / multiple cylinder misfire detected

P0171

System too lean — Bank 1

P0455

Evaporative emission system leak detected — large leak

P0128

Coolant thermostat below regulating temperature

P0442

Evaporative emission system leak detected — small leak

VIN tools

Decode factory build data for a specific vehicle by VIN.

VIN

Decode a VIN to confirm the transmission and build data for a specific Cutlass Salon. OEM

Build data

Plant, GVWR class, engine and body data for any 17-character VIN.

Recalls

Check open recall campaigns against a specific vehicle by VIN.

Vehicles with shared specs

Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.

Vehicles taking 4 qt

Reference guides

Cross-vehicle references for the kinds of data on this page.

Vehicle recalls & TSBs OBD-II trouble codes Maintenance schedules Fluid capacities & specs

Frequently asked

How much oil does the 1986 Cutlass Salon take?

4 qt of 5W-30 API, per the factory manual.

Does the 1986 Cutlass Salon have open recalls?

NHTSA lists 3 recall campaign(s) for this model year. Check your specific vehicle by VIN.