Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2019 Micra.
Engine, drivetrain, dimensions and economy.
| Overall length | 150.8 in |
| Overall width | 65.7 in |
| Overall height | 60.2 in |
| Wheelbase | 96.5 in |
| Curb weight | 2302 lb |
| Track (front / rear) | 57.5 / 57.9 in |
| Weight distribution (front / rear) | 59/41 |
Capacities, torques and tune-up values from the factory service manual.
The firing order is 1-3-4-2.
| Engine Flywheel Bolts | 80 ft-lbs |
| Engine Flywheel Bolts | 80 ft-lbs |
| Intake Manifold to Engine Bolts | 20 ft-lbs |
| Oil Pump to Cylinder BLock Bolts/Studs | 18 ft-lbs |
| Oil Pump to Cylinder BLock Bolts/Studs | 18 ft-lbs |
| Cylinder Firing Order | 1-3-4-2 |
| Curb Idle Speed (No Load) | 650 rpm |
| Curb Idle Speed Variance (No Load) | 50 rpm |
| Curb Idle Speed (Secondary Under Load) | 650 rpm |
| Curb Idle Speed Variance (Secondary Under Load) | 50 rpm |
| RPM | 51.0 |
| 1 | 14 ft. lbs., Step 2: 60 | 14 ft. lbs |
| 1 | 20 ft. lbs., Step 2: 0 ft. lbs., Step 3: 14 ft. lbs., Step 4: 60°. | 20 ft. lbs |
| 1 | 25 ft. lbs., Step 2: 25 ft. lbs. Nuts and bolts should be tightened in a crisscross pattern in three steps. Begin with the inner bolt. | 25 ft. lbs |
| 1 | 24 ft. lbs., Step 2: 60 | 24 ft. lbs |
| 1 | 24 ft. lbs., Step 2: 60°. | 24 ft. lbs |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.