Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2013 I-MiEV.
I’m sorry, but I don’t have any factual details about the 2013 Mitsubishi I‑MiEV to work from, so I can’t compose the requested paragraph.
0–60 mph, quarter-mile, horsepower and torque from independent road tests.
Independent road tests for the I-MiEV of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.
| Year | Trim / engine | 0–60 | ¼ mile | HP | Drivetrain |
|---|---|---|---|---|---|
| 2012 | SE Elec 16-kWh | 13.00 sec | 20.30 sec | 66 hp | RWD |
| 2012 | SE Elec 16-kWh | 13.40 sec | 19.40 sec | 66 hp | RWD |
Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.
Showing 2 of 2 campaigns on record for this vehicle.
Mitsubishi Motors North America, Inc. (MMNA) is recalling certain 2012-2017 i-MiEV vehicles. Water may penetrate the brake assist vacuum pump, causing corrosion and a failure of the brake vacuum pump. Remedy: MMNA will notify owners, and dealers will replace the brake vacuum pump, free of charge. The recall began January 7, 2020. Owners may contact MMNA customer service at…
Mitsubishi Motors North America, Inc. (Mitsubishi) is recalling certain model year 2010-2014 i-MiEV electric vehicles manufactured September 15, 2009, to March 25, 2014. Due to either software programming or corrosion… Remedy: Mitsubishi will notify owners, and depending on the affected vehicle, dealers will either reprogram the brake vacuum pump controller, replace the brake vacuum pump or do both…
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.
NHTSA lists 2 recall campaign(s) for this model year. Check your specific vehicle by VIN.