Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2015 S65 AMG.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI Battery group and CCA will vary by model options and region. Refer to the appropriate service information. · Battery group and CCA will vary by model options and region. Refer to the appropriate service information. CCA battery, OE oil filter 2751800009. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
| Engine oil filter | 2751800009 |
| Engine air filter | 2750940204 |
| Battery | 0019828208 alt 000982960864 |
| Front wiper blades | 2178202000 alt 2228201145 |
| Thermostat | 1372030180 alt 606997104564 |
Capacities, torques and tune-up values from the factory service manual.
This engine DOT 4 brake fluid. The firing order is 1-12-5-8-3-10-6-7-2-11-4-9. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Brake Fluid | DOT 4 |
| Engine Coolant Capacity | 14.7 |
| Fuel Tank Capacity | 21.1-21.9 gallons |
| Exhaust Manifold to Cylinder Head Bolts | 11.0 ft-lbs |
| Cylinder Firing Order | 1-12-5-8-3-10-6-7-2-11-4-9 |
| Cylinder Firing Order | 1-12-5-8-3-10-6-7-2-11-4-9 |
| Spark Plug Manufacturer | Mercedes - Benz |
| Spark Plug Gap | .031 in |
| Spark Plug Torque | 17 ft-lbs |
| Spark Plug Manufacturer | Mercedes-Benz |
| Spark Plug Gap | 0.031 in |
| Spark Plug Torque | 15.0-20.0 ft-lbs |
| Refrigerant | R134a |
| Oil Group | PAG |
| Oil Type | 46 |
| Oil Capacity | 3.38-4.06 oz |
| Brake Caliper Bolt to Carrier Torque | Front: 26; Rear: 26 /; Rear: 26 |
| Brake Caliper Carrier to Hub Bolt Torque | Front: 110; Rear: 81 /; Front: 110 Turn; Rear: 81 |
| Minimum Pad Thickness | Front: 0.079; Rear: 0.079 Vehicle |
Prep Do not reuse old bolts. Coat new bolts lightly with specified motor oil. The length of new M12 cylinder head bolts are 132mm. if the length of the M12 bolts are greater than the maximum permissible dimension of 135.5mm, replace with new cylinder head bolts.
| 1 | 29.5 ft. lbs. | 29.5 ft. lbs |
| 2 | 90 degrees | 90 degrees |
| 3 | 90 degrees | 90 degrees |
| 1 | 180 | |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.