Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2018 Maybach S650.
Fluid capacities, tune-up values and fuel economy at a glance.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
Engine, drivetrain, dimensions and economy.
| Overall length | 214.6 in |
| Overall width | 74.8 in |
| Overall height | 59.1 in |
| Wheelbase | 132.7 in |
| Curb weight | 5148 lb |
| Track (front / rear) | 63.8 / 64.6 in |
Capacities, torques and tune-up values from the factory service manual.
Torque lug nuts to 110 ft-lbs, the oil drain plug to 18.0 ft-lbs. The firing order is 1-12-5-8-3-10-6-7-2-11-4-9. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Exhaust Manifold to Cylinder Head Bolts | 11 ft-lbs |
| Exhaust Manifold to Cylinder Head Bolts | 11 ft-lbs |
| Engine Oil Pan Drain Plug | 18.0 ft-lbs |
| Oil Pump to Cylinder BLock Bolts/Studs | 15.0 ft-lbs |
| Lug Nuts | 110 ft-lbs |
| Cylinder Firing Order | 1-12-5-8-3-10-6-7-2-11-4-9 |
| Spark Plug Manufacturer | Mercedes-Benz |
| Spark Plug Gap | .031 in |
| Spark Plug Torque | 18 ft-lbs |
| Oil Type | 46 |
| Oil Group | PAG |
| Engine Compression | 174 |
| 1 | 202.0 ft. lbs., Step 2: 90 | 202 ft. lbs |
| 1 | 202.0 ft. lbs., Step 2: 90 | 202 ft. lbs |
| 1 | 30 ft. lbs. | 30 ft. lbs |
| 2 | Turn 90 degrees | 90 degrees |
| 3 | Turn 90 | |
| 1 | 33.0 ft. lbs., Step 2: 90 | 33 ft. lbs |
| 1 | 3.0 ft. lbs. | 3 ft. lbs |
| 2 | Tighten Bolts 180 | |
| 1 | 3 ft. lbs. | 3 ft. lbs |
| 2 | Tighten bolts to 180 | |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.