Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2014 E250.
Fluid capacities, tune-up values and fuel economy at a glance.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI Battery group and CCA will vary by model options and region. Refer to the appropriate service information. · Battery group and CCA will vary by model options and region. Refer to the appropriate service information. CCA battery, OE oil filter 0199971845. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
| Engine oil filter | 0199971845 alt 0199971745 |
| Battery | 0019828208 alt 000982960864 |
| Front wiper blades | 2128201700 alt 2128201900 |
| Thermostat | 651200320064 |
Capacities, torques and tune-up values from the factory service manual.
This engine DOT 4 brake fluid. Torque lug nuts to 96 ft-lbs, the oil drain plug to 22.1 ft-lbs. The firing order is 1-3-4-2. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Automatic Transmission Fluid | ATF |
| Automatic Transmission Fluid Capacity | 9.5-13.5 |
| Brake Fluid | DOT 4 |
| Intake Manifold to Engine Bolts | 6.6 ft-lbs |
| Intake Manifold to Engine Bolts | 6.6 ft-lbs |
| Engine Oil Pan Drain Plug | 22.1 ft-lbs |
| Lug Nuts | 96 ft-lbs |
| Cylinder Firing Order | 1-3-4-2 |
| Refrigerant | R134a |
| Oil Group | PAG |
| Oil Type | 46 |
| Oil Capacity | 4.10 oz |
| Pressure Test | 20.3 psi |
| Engine Compression | 333-435 psi |
| Vented Rotor Minimum Thickness for Replacement | Front: 1.181; Rear: .763 |
Prep If M12 bolts are longer than 227.50 mm the need to be replaced with new bolts. New M12 bolts have a length of 226.00 mm
| 1 | Bolts 1-10 | 7 ft. lbs |
| 2 | Bolt 13 | 15 ft. lbs |
| 3 | Bolt 12 | 15 ft. lbs |
| 4 | Bolts 1-10 | 37 ft. lbs |
| 5 | Bolt 13 | 15 ft. lbs |
| 6 | Bolt 12 | 15 ft. lbs |
| 7 | Bolts 1-10 | 90 degrees |
| 8 | Bolts 1-10 | 90 degrees |
| 9 | Bolts 1-10 | 90 degrees |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.