Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2017 CLA45 AMG.
Fluid capacities, tune-up values and fuel economy at a glance.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI 48 · 760 CCA battery, OE oil filter 2701840280. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
| Engine oil filter | 2701840280 alt 278180000990 |
| Battery | 000982960864 alt 0019828008 |
| Front wiper blades | 1768204300 |
| Thermostat | 024997634564 alt 2702002200 |
Engine, drivetrain, dimensions and economy.
| Overall length | 184.6 in |
| Overall width | 70.1 in |
| Overall height | 55.9 in |
| Wheelbase | 106.3 in |
| Curb weight | 3494 lb |
| Track (front / rear) | 61 / 60.6 in |
| Weight distribution (front / rear) | 61/39 |
Capacities, torques and tune-up values from the factory service manual.
Torque lug nuts to 96 ft-lbs. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Intake Manifold to Engine Bolts | 10.3 |
| Exhaust Manifold to Cylinder Head Bolts | 15 FT/LBS. |
| Oil Pump to Cylinder BLock Bolts/Studs | 10.0 ft-lbs |
| Lug Nuts | 96 ft-lbs |
| Standard BCI Group Number | 48 |
| Standard BCI Cranking Performance | 760 cca |
| Optional BCI Group Number | 48; AUXILLARY: 400 |
| Optional BCI Cranking Performance | 800; AUXILLARY: 200 cca |
| 1 | 7.4 ft. lbs., Step 2: 90 | 7.4 ft. lbs |
| 1 | 44.0 inch lbs., Step 2: 132.0 inch lbs., Step 3: 90 | 44 in |
| 1 | 148.0 ft. lbs. | 148 ft. lbs |
| 2 | + 90 | |
Prep Do not reuse old bolts. Use new bolts coated with clean engine oil. Tighten all bolts to finger tight then continue on with the following procedure.
| 1 | Bolts 1-10 | 14.7 ft. lbs |
| 2 | 29.5 ft. lbs. | 29.5 ft. lbs |
| 3 | 90 degrees | 90 degrees |
| 4 | 90 degrees | 90 degrees |
| 5 | 90 degrees | 90 degrees |
| 6 | 14.8 | |
| 1 | 33.0 ft. lbs., Step 2: 90 | 33 ft. lbs |
| 1 | 22.0 ft. lbs., Step 2: 90 | 22 ft. lbs |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.