MazdaGLC1983Overview/mazda/glc/1983/base/

1983 Mazda GLC

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1983 GLC.

I need the JSON data with the vehicle facts to write the paragraph. Please provide it.

Model year19851984198319821981198019791978

Full specifications

Engine, drivetrain, dimensions and economy.

Dimensions & weight NHTSA vPIC

Overall length159.1 in
Overall width64.2 in
Overall height53.9 in
Wheelbase93.3 in
Curb weight1940 lb

Performance & power Independent road tests

0–60 mph, quarter-mile, horsepower and torque from independent road tests.

Independent road tests for the GLC of this era, listed by trim and engine — this page spans more than one engine, so no single horsepower figure is shown.

13.9–14.4 sec0–60 mph (tested)quickest 13.90 sec — 1981 Sport 3-door Hatchback
YearTrim / engine0–60¼ mileHPDrivetrain
1981Sport 3-door Hatchback 1.5L I-413.90 sec19.30 sec65 hpFWD
1985LX Sedan 1.5L I-414.40 sec68 hpFWD

Service quick specs OEM factory data

Capacities, torques and tune-up values from the factory service manual.

This engine GL-5 in the differential.

Lubricants & capacities

Differential Gear OilGL-5
Differential Gear Oil Capacity1.7 Pints
Engine CoolantETHYLENE GLYCOL
Power Steering FluidATF

Reliability & federal safety record

Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.

2
Open recalls
NHTSA campaigns
3
Service bulletins
Manufacturer communications
0
ODI investigations
Office of Defects Investigation
0
Owner complaints
0 involved a crash · 0 a fire

No owner complaints on record with NHTSA for this vehicle.

Recalls NHTSA · verified

Showing 2 of 2 campaigns on record for this vehicle.

85V108000SteeringReported 04/09/1985

IN CERTAIN HIGH SALT AREAS, THE IDLER ARM IS EXPOSED TO ROAD SALT WHICH CAUSES THE DUST SEAL TO DETERIORATE RESULTING IN IDLER ARM PIN CORROSION. THIS CAUSES THE PIN TO FREEZE AND BREAK. CONSEQUENCE OF DEFECT: A BROKEN… Remedy: REPLACE PIN WITH ONE OF IMPROVED CORROSION RESISTANT QUALITY.

83V052000Seat Belts:Front:AnchorageReported 10/05/1983

ANCHORAGE BOLT MAY HAVE BEEN IMPROPERLY REINSTALLED AFTER VEHICLE REPAIR. THE BOLT COULD LOOSEN DURING NORMAL VEHICLE OPERATION. Remedy: UPON INSPECTION, ALL IMPROPERLY INSTALLED BOLTS WILL BE REMOVED AND REINSTALLED CORRECTLY.

Technical service bulletins NHTSA · verified

Showing 3 of 3 bulletins on record with NHTSA.

BulletinDateComponentSummary
008/971997-05-19EquipmentUSE OF A/C TRACER DYE. *TW
001/97G1997-04-08Electrical SystemMAINTENANCE FREE BATTERY - DIAGNOSTIC AND CHARGING PROCEDURE. *TW
003/97G1997-01-19Electrical SystemWIPER MOTOR INOPERATIVE - CIRCUIT BREAKER ACTIVATION. *TW

Common OBD-II trouble codes

The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.

P0420
Catalyst system efficiency below threshold — Bank 1
P0300
Random / multiple cylinder misfire detected
P0171
System too lean — Bank 1
P0455
Evaporative emission system leak detected — large leak
P0128
Coolant thermostat below regulating temperature
P0442
Evaporative emission system leak detected — small leak

VIN tools

Decode factory build data for a specific vehicle by VIN.

VIN
Decode a VIN to confirm the transmission and build data for a specific GLC. OEM
Build data
Plant, GVWR class, engine and body data for any 17-character VIN.
Recalls
Check open recall campaigns against a specific vehicle by VIN.

Reference guides

Cross-vehicle references for the kinds of data on this page.

Frequently asked

Does the 1983 GLC have open recalls?

NHTSA lists 2 recall campaign(s) for this model year. Check your specific vehicle by VIN.