Fluid capacities, tune-up values and fuel economy at a glance.
Engine oil capacity6.0 qtOEM · verified
Engine oil type0W-20OEM · verified
Lug nut torque140 ft-lbsOEM · verified
Fitment & sizes
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI 94R · 720 CCA battery, OE oil filter 12731742. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
Battery groupBCI 94R · 720 CCAOEM · verified
Tire sizeP265/65R18OEM · verified
Wheel / rimNS inOEM · verified
OE service part numbers OEM · verified
Engine oil filter
12731742
Engine air filter
23349854
Spark plug
12622441
Battery
88864541 alt 88865934
Front wiper blades
84613732
Serpentine belt
12658178 alt 12643517
Thermostat
12620318 alt 12674639
Cabin air filter
23281440
Service quick specs OEM factory data
Capacities, torques and tune-up values from the factory service manual.
This engine holds 6.0 qt of 0W-20 engine oil, Synthetic · 75W-90 · GL-5 · 75W-85 in the differential, DOT 3 brake fluid. Torque lug nuts to 140 ft-lbs, the oil drain plug to 18.0 ft-lbs. The firing order is 1-2-7-8-4-5-6-3. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
Intake Manifold to Engine Bolts — tightening sequence 1 stages
1
7.4
Intake Manifold to Engine Bolts — tightening sequence 1 stages
1
7.4
Main Bearings — tightening sequence 2 stages
Prep Inner bolts
1
22.0 ft. lbs.
22 ft. lbs
2
110 degrees; Outer bolts
110 degrees
1
15.0 ft. lbs.
15 ft. lbs
2
80.0 degrees; Side bolts
80 degrees
1
15.0 ft. lbs.
15 ft. lbs
2
60.0 degrees
60 degrees
Main Bearings — tightening sequence 2 stages
Prep Inner bolts
1
22.0 ft. lbs.
22 ft. lbs
2
110 degrees; Outer bolts
110 degrees
1
15.0 ft. lbs.
15 ft. lbs
2
80.0 degrees; Side bolts
80 degrees
1
15.0 ft. lbs.
15 ft. lbs
2
60.0 degrees
60 degrees
Factory maintenance schedule OEM · verified
Normal service, condensed from the factory interval matrix.
Under the factory schedule, replace the engine oil and filter every 7,500 mi; spark plugs every 97,500 mi; coolant at 150,000 mi. The big-interval services (at 150,000 mi for coolant, and the transmission fluid) are the ones owners most often skip — on a lower-mileage example, assume the original fluids are still in it and check them first.
Every 7,500 mi
Accelerator Pedal (inspect) · Body Latches, Locks & Hinges (lubricate) · Brake Shift Interlock Solenoid (inspect) · Brake System (inspect) · Engine Air Filter Element (inspect) · Engine Oil (inspect fluid level)
Every 22,500 mi
Cabin Air Filter (replace)
Every 45,000 mi
Fuel Evaporative Emission Control System (inspect)
Every 97,500 mi
Spark Plug Wires (inspect) · Spark Plugs (replace) · Transfer Case Assembly (drain & refill)
At 150,000 mi
Accessory Drive Belt (inspect) · Engine Coolant System (drain, flush & refill)
Common OBD-II trouble codes
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.