Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2004 W-Series MD Tilt Chassis.
Capacities, torques and tune-up values from the factory service manual.
Torque the oil drain plug to 18.0 ft-lbs. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Engine Oil Pan Drain Plug | 18.0 ft-lbs |
| Engine Oil Pan Drain Plug | 18.0 ft-lbs |
| Spark Plug Manufacturer | AC Delco |
| Spark Plug Gap | 0.060 in |
| Spark Plug Torque | 11 ft-lbs |
| Engine Compression | 100 Minimum psi |
| Engine Compression | 215 Nominal psi |
| Engine Compression | 100 Minimum psi |
| Engine Compression | 100 Minimum psi |
| 1 | M11 bolts | 22 ft. lbs |
| 2 | M11 bolts-90 degrees | 90 degrees |
| 3 | M11 bolts 1-8 | 90 degrees |
| 4 | M11 bolts 9 and 10 | 50 degrees |
| 5 | 22 | |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Cross-vehicle references for the kinds of data on this page.