FordSpecial Service Police Sedan2017Overview/ford/special-service-police-sedan/2017/base/

2017 Ford Special Service Police Sedan

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2017 Special Service Police Sedan.

The 2017 Ford Special Service Police Sedan takes 5.7 qt of 5W-30 engine oil.

Quick specs

Fluid capacities, tune-up values and fuel economy at a glance.

Engine oil capacity5.7 qtOEM · verified
Engine oil type5W-30 / 5W-20OEM · verified

Fitment & sizes

Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.

From the factory this vehicle uses a BCI 65 · 750 CCA battery. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.

Battery groupBCI 65 · 750 CCAOEM · verified
Tire sizeNSOEM · verified
Wheel / rimNS inOEM · verified

Service quick specs OEM factory data

Capacities, torques and tune-up values from the factory service manual.

This engine holds 5.7 qt of 5W-30 / 5W-20 engine oil, 80W-90 · GL-5 in the differential, DOT 4 brake fluid. The firing order is 1-3-4-2.

Lubricants & capacities

Automatic Transmission Fluid Capacity9.0-11.0
Brake FluidDOT 4
Differential Gear Oil80W-90 · GL-5
Differential Gear Oil Capacity1.30-2.45
Engine Coolant Capacity11.6
Engine Oil5W-30 · 5W-20
Engine Oil Capacity5.7 qt
Power Steering FluidEPS

Engine torques

Oil Pump to Cylinder BLock Bolts/Studs15.0 ft-lbs

Chassis torques

Steering Track (Rod End) Bolts111.0 ft-lbs
Front Wheel Hub258.0 ft-lbs

Ignition

Cylinder Firing Order1-3-4-2

Battery & A/C

Standard BCI Group Number65
Standard BCI Cranking Performance750 cca

Brakes

Minimum Pad Thickness0.118 in
Vented Rotor Minimum Thickness after RefinishStamped on rotor
Vented Rotor Maximum Scoring DepthStamped on rotor
Maximum Rotor Runout0.002

Multi-step torque procedures OEM · verified

Camshaft Bearing/Carrier Cap Bolts or Studs — tightening sequence 2 stages
162.0 inch lbs.62 in
2142.0 inch lbs.142 in
Connecting Rod (Large End) Bearings — tightening sequence 4 stages
189.0 inch lbs.89 in
2Back off bolts 360.0 degrees360 degrees
321.0 ft. lbs.21 ft. lbs
490.0
Crankshaft Pulley and/or Damper Bolts — tightening sequence 2 stages
174.0 ft. lbs.74 ft. lbs
2+ 90
Engine Flywheel Bolts — tightening sequence 2 stages
137.0 ft. lbs.; Step 2; 59.0 ft. lbs.37 ft. lbs
383.0
Main Bearings — tightening sequence 3 stages
144.0 inch lbs.44 in
218.0 ft. lbs.18 ft. lbs
390.0

Factory maintenance schedule OEM · verified

Normal service, condensed from the factory interval matrix.

Under the factory schedule, replace the spark plugs every 100,000 mi; coolant every 50,000 mi. The big-interval services (every 50,000 mi for coolant, and the transmission fluid) are the ones owners most often skip — on a lower-mileage example, assume the original fluids are still in it and check them first.

Every 10,000 miBrake Line (inspect) · Brake Linings (inspect) · Brake Rotor (inspect) · CV Joint Boot (inspect) · Engine Coolant System (inspect fluid level) · Engine Coolant System Hoses (inspect)
Every 20,000 miAccessory Drive Belt (inspect) · Cabin Air Filter (replace)
Every 30,000 miEngine Air Filter Element (replace)
Every 50,000 miEngine Coolant System (drain, flush & refill)
At 100,000 miAccessory Drive Belt (inspect) · Engine Coolant System (drain, flush & refill)
Every 100,000 miSpark Plugs (replace)
At 150,000 miDrive Belt (replace) · Transmission Assembly (drain & refill)

Common OBD-II trouble codes

The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.

P0420
Catalyst system efficiency below threshold — Bank 1
P0300
Random / multiple cylinder misfire detected
P0171
System too lean — Bank 1
P0455
Evaporative emission system leak detected — large leak
P0128
Coolant thermostat below regulating temperature
P0442
Evaporative emission system leak detected — small leak

VIN tools

Decode factory build data for a specific vehicle by VIN.

VIN
Decode a VIN to confirm the transmission and build data for a specific Special Service Police Sedan. OEM
Build data
Plant, GVWR class, engine and body data for any 17-character VIN.
Recalls
Check open recall campaigns against a specific vehicle by VIN.

Vehicles with shared specs

Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.

Reference guides

Cross-vehicle references for the kinds of data on this page.

Frequently asked

How much oil does the 2017 Special Service Police Sedan take?

5.7 qt of Turbo: 5W-30 Meeting Ford specification WSS-M2C946-A or equivalent., Non-Turbo: 5W-20 Meeting Ford specification WSS-M2C945-A or equivalent., per the factory manual.