FordE-4502007Overview/ford/e-450/2007/base/
450 platform

2007 Ford E-450

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2007 E.

Body VANTransmission Automatic 6-spd

The 2007 Ford E‑450 is a full‑size van built on the 450 platform and powered by a drivetrain that requires 6.0 qt of 5W‑20 API oil, paired with a six‑speed automatic transmission and delivering 16 mpg city/22 mpg highway/18 mpg combined according to EPA ratings. Across its model span from 1992 to 2027, the E‑450’s complaint record peaks at 80 issues in 1999 and bottoms out at a single report in 1996, placing the 2007 iteration near the low‑end of the spectrum with only 12 owner complaints—most of which pertain to the engine—and a total of 23 recalls recorded for the line. This modest complaint count suggests that the 2007 model sits in a relatively reliable period of the van’s history, offering researchers a baseline of stability amid the broader variability of the series.

Model year20172016201520142007

Quick specs

Fluid capacities, tune-up values and fuel economy at a glance.

Engine oil capacity6.0 qtOEM · verified
Engine oil type5W-20 APIOEM · verified
EPA fuel economy16/22/18 mpgEPA · verified

Fitment & sizes

Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.

From the factory this vehicle uses a BCI 65 - PRIMARY BATTERY · 650 - PRIMARY BATTERY CCA battery. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.

Battery groupBCI 65 - PRIMARY BATTERY · 650 - PRIMARY BATTERY CCAOEM · verified

Full specifications

Engine, drivetrain, dimensions and economy.

Engine & drivetrain NHTSA vPIC

TransmissionAutomatic 6-spd

Dimensions & weight NHTSA vPIC

Overall length211.8 in
Overall width79.5 in
Overall height81.1 in
Wheelbase138.2 in
Curb weight4645 lb
Track (front / rear)70.1 / 66.9 in
Weight distribution (front / rear)58/42

Ratings & economy EPA / vPIC

EPA city / highway / combined16 / 22 / 18 mpg
Drivetrain4-Wheel or All-Wheel Drive
Recommended fuelRegular Gasoline

Service quick specs OEM factory data

Capacities, torques and tune-up values from the factory service manual.

This engine holds 6.0 qt of 5W-20 API engine oil. Torque the oil drain plug to 10.0 ft-lbs. The firing order is 1-2-7-3-4-5-6-8. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.

Lubricants & capacities

Automatic Transmission FluidFord Mercon LV
Automatic Transmission Fluid Capacity7.4
Engine Oil5W-20 · API
Engine Oil Capacity6.0 qt
Engine Oil5W-20 · API
Engine Oil Capacity7.0 qt
Engine Oil15W-40 · 10W-30 · 0W-30
Engine Oil Capacity15.0 qt

Engine torques

Engine Flywheel Bolts59 ft-lbs
Intake Manifold to Engine Bolts8 ft-lbs
Exhaust Manifold to Cylinder Head Bolts28 ft-lbs
Exhaust Manifold to Cylinder Head Bolts18 ft-lbs
Engine Oil Pan Drain Plug10.0 ft-lbs
Engine Oil Pan Drain Plug18.0 ft-lbs
Engine Oil Pan Drain Plug10.0 ft-lbs
Oil Pump to Cylinder BLock Bolts/Studs7 ft-lbs

Chassis torques

Leaf Spring to Chassis Bracket258.0 ft-lbs
Leaf Spring to Rear Shackle98.0 ft-lbs
Leaf Spring Rear Shackle to Chassis Bracket98.0 ft-lbs

Ignition

Cylinder Firing Order1-3-7-2-6-5-4-8
Cylinder Firing Order1-2-7-3-4-5-6-8
Ignition Timing10

Battery & A/C

RefrigerantR134a
Oil GroupPAG
Oil Type46
Standard BCI Group Number65 - PRIMARY BATTERY
Standard BCI Cranking Performance650 - PRIMARY BATTERY cca
Standard BCI Group Number65 - PRIMARY BATTERY
Standard BCI Cranking Performance650 - PRIMARY BATTERY cca
Standard BCI Group Number65 DIESEL

Service checks

Key ON Engine OFF (KOEO)0-55
RPM45-55 @ Idle rpm
Key ON Engine OFF (KOEO)35-45
RPM28-45 @ Idle rpm
Injector Primary Resistance11-18 na ohms
Injector Primary Resistance11-18 na ohms
Engine Oil Pressure40-125 psi
Engine Oil Pressure RPM2500 rpm

Brakes

Torque Caliper to Bracket23 ft-lbs / 26 ft-lbs
Torque to Knuckle166 ft-lbs / 87 ft-lbs
Minimum Pad ThicknessFront: 0.118; Rear: 0.118 in
Minimum Pad ThicknessFront: 0.118; Rear: 0.118 in
Rotor Discard at or Under1.102 in / 1.429 in

Multi-step torque procedures OEM · verified

Connecting Rod (Large End) Bearings — tightening sequence 1 stages
133 ft. lbs., Step 2: 5033 ft. lbs
Connecting Rod (Large End) Bearings — tightening sequence 1 stages
132 ft. lbs., Step 2: 10532 ft. lbs
Crankshaft Pulley and/or Damper Bolts — tightening sequence 1 stages
166 ft. lbs., step 2: loosen one turn 37 ft. lbs., step 3: 9066 ft. lbs
Crankshaft Pulley and/or Damper Bolts — tightening sequence 1 stages
150 ft. lbs., step 2: 9050 ft. lbs
Cylinder Head — tightening sequence 3 stages
130 ft. lbs.30 ft. lbs
290 degrees90 degrees
390
Cylinder Head — tightening sequence 7 stages
1Bolts 1 thru 1065 ft. lbs
2Bolts 1, 3, 5, 7 and 985 ft. lbs
3Bolts 1 thru 1090 degrees
4Bolts 1 thru 1090 degrees
5Bolts 1 thru 1090 degrees
6Bolts 11 thru 1518 ft. lbs
7Bolts 11 thru 1523 ft. lbs
Engine Flywheel Bolts — tightening sequence 1 stages
14 ft. lbs., Step 2: 694 ft. lbs
Intake Manifold to Engine Bolts — tightening sequence 1 stages
11.5 ft. lbs., Step 2: 181.5 ft. lbs
Main Bearings — tightening sequence 1 stages
190 ft. lbs., Step 2: 120 ft. lbs., Step 3: 17090 ft. lbs

Factory maintenance schedule OEM · verified

Normal service, condensed from the factory interval matrix.

Under the factory schedule, replace the engine oil and filter every 5,000 mi; spark plugs every 100,000 mi; coolant every 30,000 mi. The big-interval services (every 30,000 mi for coolant, and the transmission fluid) are the ones owners most often skip — on a lower-mileage example, assume the original fluids are still in it and check them first.

Every 5,000 miEngine Oil (drain & refill) · Engine Oil Filter (replace) · Tire & Wheel Assembly (rotate)
Every 15,000 miBrake System (inspect) · Cabin Air Filter (replace) · Driveshaft U-Joint (inspect) · Engine Coolant System Hoses (inspect) · Steering Linkage (lubricate) · Steering System (inspect)
Every 30,000 miEngine Air Filter Element (replace) · Engine Coolant System (drain, flush & refill) · Exhaust System (Complete) (inspect) · Fuel Filter (replace) · Temperature Controlled Seat Air Filter (replace) · Transmission Fluid & Filter (replace)
At 45,000 miEngine Coolant System (drain, flush & refill)
Every 60,000 miWheel Bearing (repack)
Every 100,000 miAccessory Drive Belt (inspect) · Drive Axle Assembly (drain & refill) · PCV Valve (replace) · Spark Plugs (replace)
At 150,000 miDrive Belt (replace)

Reliability & federal safety record

Owner-reported issues, recalls, investigations and service bulletins on record with NHTSA — an unfiltered look at what owners actually experience.

The E-450 generation saw a clear escalation in federal recalls starting in 2005, with 2006 and 2007 forming a distinct peak at 12 and 11 recalls respectively, far above the 1–5 recalls typical of earlier years. Complaints, however, peaked earlier in 2005 at 33 and then declined sharply to 12 in 2007, while TSBs also dropped from 70 in 2005 to 23 in 2007, suggesting that many issues were being resolved through the recall campaigns rather than left to owner complaints. The 2007 model year’s top complaint areas are concentrated in the engine and electrical system, but with only 12 total complaints and zero crash or fire incidents, the data does not indicate widespread catastrophic failures. This year sits at the tail end of a high-recall correction period, implying that many potential problems were identified and addressed proactively. If you can verify that all 11 recalls have been completed, the 2007 E-450 represents a relatively low-complaint year within a generation that saw significant manufacturer remediation.

23
Open recalls
NHTSA campaigns
19
Service bulletins
Manufacturer communications
0
ODI investigations
Office of Defects Investigation
12
Owner complaints
0 involved a crash · 0 a fire
NHTSA crash-test rating federal NCAP · out of 5 stars
Rollover★★★★★

Owner complaints filed with NHTSA, by component

All 12 complaints on record, top 8 components.

Engine3
Suspension,Electrical System1
Electrical System,Engine1
Air Bags1
Fuel/Propulsion System1
Engine & Engine Cooling1
Vehicle Speed Control1
Service Brakes, Hydraulic,Vehicle Speed Control1

Source: NHTSA Office of Defects Investigation complaint database.

Recalls NHTSA · verified

Showing 2 of 18 campaigns on record for this vehicle.

14V279000Equipment Adaptive/MobilityReported 27/05/2014

Mobility Specialists, Inc. (Mobility Specialists) is recalling certain model year 2007-2008 Ford E-150 vans modified by Mobility Specialists and equipped with Braun NCL-2, and NVL-2 wheel chair lifts. Over time, and… Remedy: Mobility Specialists will notify owners and will replace the affected parts, free of charge. The recall began in July 2014. Owners may contact Mobility Specialists customer…

15V729000Equipment Adaptive/MobilityReported 04/11/2015

MobilityWorks (WMK Inc.) is recalling certain model year 2006-2014 Ford E-150, E-250, and E-350 vans modified by MobilityWorks to be equipped with certain model S2005, S2010, S5005, S5010, S5505, and S5510 wheelchair… Remedy: MobilityWorks will notify owners, and Ricon dealers will inspect the link arms for damage or for displaced bearings. The platform will be inspected for cracks. Any damaged parts…

Technical service bulletins NHTSA · verified

Showing 5 of 19 bulletins on record with NHTSA.

BulletinDateComponentSummary
SSM 519092023-09-07Power TrainWhen performing any transmission fluid changes or topoffs involving MERCON SP, MERCON LV…
SSM 460852016-09-21Engine And Engine CoolingThe Powertrain Control/Emissions Diagnosis (PC/ED) manual has been revised for diagnosing…
ASI-445342014-05-01Power TrainFORD: WHEN SHIFTING BETWEEN PARK, REVERSE AND/OR DURING 2-3 SHIFT, AN INTERMITTENT CLUNK…
ASI-444042014-02-01Power TrainFORD: ON SOME TRUCKS, THERE IS A NO CRANK SITUATION AND IF VOLTAGE ON TRANSMISSION RANGE…
TSB-11-11-212011-11-17Engine And Engine CoolingFORD: THE BLOWER MOTOR ON SOME VEHICLES ARE OPERATING EITHER INCORRECTLY OR NOT OPERATING…

Common OBD-II trouble codes

The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.

P0420
Catalyst system efficiency below threshold — Bank 1
P0300
Random / multiple cylinder misfire detected
P0171
System too lean — Bank 1
P0455
Evaporative emission system leak detected — large leak
P0128
Coolant thermostat below regulating temperature
P0442
Evaporative emission system leak detected — small leak

VIN tools

Decode factory build data for a specific vehicle by VIN.

VIN
Decode a VIN to confirm the transmission and build data for a specific E. OEM
Build data
Plant, GVWR class, engine and body data for any 17-character VIN.
Recalls
Check open recall campaigns against a specific vehicle by VIN.

Vehicles with shared specs

Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.

Reference guides

Cross-vehicle references for the kinds of data on this page.

Frequently asked

How much oil does the 2007 E take?

6.0 qt of 5W-20 API MEETING FORD SPECIFICATION WSS-M2C945-A, per the factory manual.

Does the 2007 E have open recalls?

NHTSA lists 23 recall campaign(s) for this model year. Check your specific vehicle by VIN.

What gas mileage does the E get?

EPA figures are 16 city / 22 highway / 18 combined mpg.