Chevrolet›W-Series MD Tilt Chassis›1996›Overview/chevrolet/w-series-md-tilt-chassis/1996/base/

1996 Chevrolet W-Series MD Tilt Chassis

Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 1996 W-Series MD Tilt Chassis.

Service quick specs OEM factory data

Capacities, torques and tune-up values from the factory service manual.

Crankshaft Pulley and/or Damper Bolts

74 ft-lbs

Injector Primary Resistance	11.8-12.6 @ 50-95 degreesF MFI ohms
Engine Compression	100 Minimum psi
Engine Compression	215 Nominal psi
Engine Compression	100 Minimum psi
Engine Compression	100 Minimum psi

The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.

Catalyst system efficiency below threshold — Bank 1

Random / multiple cylinder misfire detected

System too lean — Bank 1

Evaporative emission system leak detected — large leak

Coolant thermostat below regulating temperature

Evaporative emission system leak detected — small leak

Decode factory build data for a specific vehicle by VIN.

VIN

Decode a VIN to confirm the transmission and build data for a specific W-Series MD Tilt Chassis. OEM

Build data

Plant, GVWR class, engine and body data for any 17-character VIN.

Recalls

Check open recall campaigns against a specific vehicle by VIN.

Cross-vehicle references for the kinds of data on this page.