Factory specifications, fluid capacities, torque values, EPA fuel economy and the federal safety record for the 2010 750i xDrive Sedan.
The 2010 BMW 750i xDrive Sedan. It takes 9.0 qt of 15W-40 engine oil and is EPA-rated at 14/20/16 mpg city/highway/combined.
Fluid capacities, tune-up values and fuel economy at a glance.
Replacement part sizes and factory part numbers — battery, bulbs, filters and belts.
From the factory this vehicle uses a BCI 49 · 900 CCA battery, OE oil filter 11427583220. Each part links to every other vehicle that shares it, so a part you already stock may fit more of your fleet than you'd expect.
| Engine oil filter | 11427583220 |
| Engine air filter | 13717577458 alt 13717577457 |
| Spark plug | 12120037580 |
| Battery | 61217594976 |
| Front wiper blades | 61612147361 |
| Thermostat | 11538632664 alt 11537586885 |
| Cabin air filter | 64119272642 |
Engine, drivetrain, dimensions and economy.
| Transmission | Automatic (S6) |
| Overall length | 199.6 in |
| Overall width | 74.8 in |
| Overall height | 58.3 in |
| Wheelbase | 120.9 in |
| Curb weight | 4564 lb |
| Track (front / rear) | 63.4 / 64.2 in |
| Weight distribution (front / rear) | 50/50 |
| EPA city / highway / combined | 14 / 20 / 16 mpg |
| Drivetrain | All-Wheel Drive |
| Passenger volume | 106 cu ft |
| Cargo volume | 14 cu ft |
| Recommended fuel | Premium Gasoline |
Capacities, torques and tune-up values from the factory service manual.
This engine holds 9.0 qt of 15W-40 / 10W-40 / 10W-30 API SJ engine oil. Torque lug nuts to 103 ft-lbs, the oil drain plug to M12 Bolts: 18.0, M22 Bolts: 44.0 ft-lbs. The firing order is 1-5-4-8-6-3-7-2. Note the cylinder-head bolts finish on a torque angle (torque-to-yield) — they stretch permanently and should be replaced, not reused, during any head service.
| Automatic Transmission Fluid | BMW part number 83222152426 |
| Automatic Transmission Fluid Capacity | 10.5-11.5 |
| Differential Gear Oil Capacity | 1.2 Pints |
| Differential Gear Oil Capacity | 1.8 Pints |
| Engine Oil | 15W-40 · API · 10W-40 · 10W-30 · 5W-30 |
| Engine Oil Capacity | 9.0 qt |
| Engine Oil Capacity | 9.0 qt |
| Power Steering Fluid | Use Pentosin CHF 11S |
| Engine Oil Pan Drain Plug | M12 Bolts: 18.0, M22 Bolts: 44.0 ft-lbs |
| Lug Nuts | 103 ft-lbs |
| Front Wheel Hub | 310 ft-lbs |
| Cylinder Firing Order | 1-5-4-8-6-3-7-2 |
| Spark Plug Manufacturer | BMW |
| Refrigerant | R134a |
| Oil Group | PAG |
| Standard BCI Group Number | 49 |
| Standard BCI Cranking Performance | 900 cca |
| Optional BCI Group Number | 49 |
| Optional BCI Cranking Performance | 850 cca |
| Pressure Test | 21.7 psi |
| Radiator Cap Pressure Relief | 26-30 psi |
| Brake Application | WITH 12.76 ROTOR / WITH FN3 |
| Torque Caliper to Bracket | 26 ft-lbs |
| Torque to Knuckle | 81 ft-lbs |
| Minimum Pad Thickness | Front: 0.145; Rear: 0.145 pads |
| Brake Application | WITH 12.76 ROTOR / WITH FN3 |
| Rotor Nominal Thickness From | 0.787 in / 1.181 in / 0.945 in / 1.417 in |
| Rotor Nominal Thickness To | 0.787 in / 1.181 in / 0.945 in / 1.417 in |
| Rotor Minimum Machining | 0.031 in |
| 1 | 73 ft. lbs., step 2: 60 degrees, step 3: 60 degrees, step 4: 60 | 73 ft. lbs |
| 1 | 22.0 ft. lbs. | 22 ft. lbs |
| 2 | 90 degrees | 90 degrees |
| 3 | 90 degrees | 90 degrees |
Normal service, condensed from the factory interval matrix.
Under the factory schedule, replace the spark plugs every 60,000 mi.
| Every 60,000 mi | Spark Plugs (replace) |
| Every 100,000 mi | Transmission Assembly (drain & refill) |
| At 120,000 mi | Oxygen Sensor (replace) |
The most common OBD-II codes for this vehicle's emissions system. These are standardized SAE J2012 definitions, not vehicle-specific fault reports.
Decode factory build data for a specific vehicle by VIN.
Find every vehicle that shares this one's battery, bulbs, oil capacity, platform or parts.
Cross-vehicle references for the kinds of data on this page.
9.0 qt of HIGH PERFORMANCE MINERAL OILS: ABOVE 5 degrees F: 15W-40 API SJ, SL OR SM, -5 degreesF TO 68 degrees F: 10W-40 API SJ, SL OR SM, 5 degreesF TO 50 degrees F: 10W-30 API SJ, SL OR SM, BELOW 50 degrees F: 5W-30 API SJ, SL OR SM, BELOW 32 degrees F:, per the factory manual.
EPA figures are 14 city / 20 highway / 16 combined mpg.